pins in 58 dynapowers

pins in 58 dynapowers

Postby IanB » Mon Apr 14, 2014 12:01 pm

I wave a set of 58 dynapowers I want to reshaft and the pins will not budge does anyone know if they are threaded?
The pins in my hogans were a piece of cake compared to these anyone have any experience with these?

Kindest, IanB
There is DO and there is DO NOT. There is no TRY.
IanB
 
Posts: 256
Joined: Mon Dec 23, 2013 11:57 am

Re: pins in 58 dynapowers

Postby NRG » Mon Apr 14, 2014 1:55 pm

They should come out. They will probably be tapered, so make sure you are trying to knock them out from the thin end and not wedging them in tighter by hitting from the thick end.

If you are not going to save the shafts, you can cut the shaft about 3" above the hosel then drill down the shaft and through the middle of the pin then the 2 ends will come out quite easily. Make sure you leave enough shaft (3") so you can grip it in a vice to twist the head off.
User avatar
NRG
 
Posts: 1078
Joined: Mon Oct 19, 2009 12:19 pm

Re: pins in 58 dynapowers

Postby mdrretired » Mon Apr 14, 2014 8:51 pm

I have had some luck with a little PB Blaster and a stubby pin punch for control. Another key is to make sure the hosel is on a flat and hard surface that will not flex with the hammer blow. I made a set of aluminum vise pads that hold the club securely and do not give with the blow.
mdrretired
 
Posts: 112
Joined: Mon May 16, 2011 7:23 pm

Re: pins in 58 dynapowers

Postby IanB » Sun Apr 27, 2014 2:35 pm

Hey there all you tech guys out there quick question.
Are 58 Dynapower shafts threaded on ?
There is DO and there is DO NOT. There is no TRY.
IanB
 
Posts: 256
Joined: Mon Dec 23, 2013 11:57 am

Re: pins in 58 dynapowers

Postby mdrretired » Sun Apr 27, 2014 5:19 pm

Can't say for sure but most probably a threaded shaft. You need to lever them forward, or clockwise as you look at the sole (hitting would actually tighten the screw-shaft a bit). Many of these were not glued but forced on then pinned so it may not take as much heat. Good luck
mdrretired
 
Posts: 112
Joined: Mon May 16, 2011 7:23 pm


Return to The Persimmon Age (Steel)

Who is online

Users browsing this forum: No registered users and 2 guests

cron